I decided to trial something a little different this weekend and made a desk lamp.

Most would expect me to jump on the lathe and turn an elaborately machined pole, but that’s been done so many times before I thought I’d let me inspiration run wild and so ended up with a wiggly lamp.

It’s a square cross section all the way up but bends in all directions up to the lamp holder.

Just to make life harder, the cable runs down inside the curves and pops out of the side of the base.

I’m also extremely lazy so the final step was to plug it into a smart switch so that I can turn it in and off with voice commands.

Leave a Reply

Your email address will not be published. Required fields are marked *